Jeep Wrangler Fan Only Works On High

Removing the leaves that had filled up in there fixed the switching from floor to defrost and the resistor fixed the speed control.
Jeep wrangler fan only works on high. Where is it located jeep 2006 wrangler question. 2005 jeep laredo heater ac fan speed control only works on high. Join thousands of other jeep fans as we tackle wrangler problems and more. Folks this is a tough one.
My fan would only work on high and the switch from floor to defrost had stopped working also. I googled the heck out of this and i m more than satisfied that the most likely culprit is the blower resistor. It will be located under the dash close to the blower motor itself. I went to the dealer today to buy a switch and they said it is most likely the unit that controls the vent gates.
My 2000 tj blower switch only works on high not the first three settings. What else could it be. 1998 jeep wrangler 4 0 i6 33x12 50 goodyear wrangler duratracs 3 inch zone suspension lift rubicon express. I have heard this is due to a resistor.
Sounds like its a bad blower motor connector find blower motor connector and perform a wiggle test while turning fan switch up and down also look at connector for melted wires or the connector itself hope. They said the dash would need to come apart and it could be just an adjustment. You ll be able to meet friends as well as get help repairing and upgrading your jeep. I said thanks but no thanks.
Usually when the fan works only on high speed the issue is with the blower motor resistor.